[TenTec] TT 705 Mic

[DW Holtman]

Don,

Thank you for the response. This mic has a place for a 9 volt battery. I 
assume it gets battery power. It has an 8 pin plug, I will have to install a 
4 pin plug. So if you say the pre-amp is needed, I will install the battery 
and wire it for the 4 pin plug.

Thank you,
DW Holtman
WB7SSN



----- Original Message ----- 
From: "Don Steele" <dsteele at iowatelecom.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Tuesday, January 06, 2009 5:26 PM
Subject: Re: [TenTec] TT 705 Mic


> DW, The 705 should be wired to plug directly into the Omni 6. It uses the
> pre amp and should obtaing its power from the rig.
>
> Don
> NT0F
>
> ----- Original Message ----- 
> From: "DW Holtman" <tubestuff at comcast.net>
> To: <n2wjw at yahoo.com>; "Discussion of Ten-Tec Equipment"
> <tentec at contesting.com>
> Sent: Tuesday, January 06, 2009 5:52 PM
> Subject: [TenTec] TT 705 Mic
>
>
>> Hello,
>>
>> I just aquired a Omni VI Plus and from a different source, I have a 705
>> mic.
>> I'm not familiar with thie mic. It has a circuit board (pre-Amp) built 
>> in.
>> My question, should I use the pre-amp or bypass it and connect the output
>> directly to the Omni VI?
>>
>> Thank you in advance for any advice.
>>
>> Best,
>> DW Holtman
>> WB7SSN
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec