[TenTec] Orion-1 problem

bill ogden billogden at optonline.net
Fri Jun 26 09:45:01 PDT 2009


I had many suggestions to reseat the cables.  I did this, including a slight twist on all the small coax cables on the top chassis, the bottom chassis, and the front panel.  Also tried flexing the panel (just a little bit).  Absolutely no reaction.

Sub receiver works well.  Main receiver acts as if no antenna is attached, BUT the sweep (with the latest beta firmware) indicates normal signals so signals must be entering the main receiver. Transmitter is OK.  (Problem started before installing the latest firmware, so that is not the problem.)

Master reset did not solve the problem, either.  

Rats.

Bill - W2WO


More information about the TenTec mailing list