[TenTec] Orion 565 Problem with 2.063Xg??

[Gary Jacek]

I have the same result using Ham Radio Deluxe Version 4.0 SP4 build 1901.

Gary
VE7AQ

-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Rick W
Sent: May 14, 2009 10:28 PM
To: Ten-Tec Reflector
Subject: [TenTec] Orion 565 Problem with 2.063Xg??



I think I've found a problem with 2.063Xg.  Here's the scenario.

    1) I have my 565 under the control of the N4PY software.
    2) I go to the RX menu and toggle the AGC System Type (it doesn't seem
to matter which way I go).
    3) Back out of the menus

After doing this exercise I lose all serial control of the Orion.  In
addition the remote pod doesn't work.  The work-around is to turn off the
software and reboot the Orion.

IF I am not using the serial port with an external program and toggle the
AGC the remote pod works BUT when I try to start some external software the
serial port is dead.  The same work-around solves the problem.

Before I report this to T-T I'd be curious if others are experiencing this?

Thanks.


73,

Rick

VE7TK



Website:  http://www3.telus.net/ve7tk


      __________________________________________________________________
The new Internet Explorer® 8 - Faster, safer, easier.  Optimized for Yahoo!
Get it Now for Free! at http://downloads.yahoo.com/ca/internetexplorer/
_______________________________________________
TenTec mailing list
TenTec at contesting.com http://lists.contesting.com/mailman/listinfo/tentec