[TenTec] Omni V problem

[waltk8cv4612amos at att.net]

And in a small voice was heard ........

" what reset button " ???

Walt K8CV Royal Oak, MI.


----- Original Message ----- 
From: "Tony Berg" <tony.w1ot at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, November 02, 2009 12:14 PM
Subject: Re: [TenTec] Omni V problem


> Hi Dennis,
>
> Is the meter lamp on when the Omni V POWER switch is off? Probably
> not, and if this is the case, the meter lamp being on when the Omni V
> POWER switch is on should indicate that+13.5v is being fed to all
> circuits from the DC Power board. I assume that you have tried pushing
> the RESET button.
>
> 73, Tony  W1OT
>
> On 11/2/09, Denton <denton at oregontrail.net> wrote:
>> Wiggle the power supply's connector on the back of the Omni....sounds 
>> like
>> something in the power supply chain.
>> ----- Original Message -----
>> From: "Dennis Kippa" <kw5g at yahoo.com>
>> To: <TenTec at contesting.com>
>> Sent: Sunday, November 01, 2009 5:54 PM
>> Subject: [TenTec] Omni V problem
>>
>>
>>>I was tuning up on 75 meters tonite when the Omni V shut down suddenly. 
>>>SWR
>>>
>>>was below 1.5 to one.  I reset the power supply but only the light on the
>>>meter came back on. No receive and the freq will not display.  Any ideas
>>>where to start looking???
>>>
>>> Dennis n5dpk
>>>
>>>
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec