[TenTec] 961 on the left side of rig

[David Drake]

Yes, I think I read some time back that in some cases you need extra 
shielding either in the mic input or the case.  My setup is identical to 
yours, ....moved it to the left side and hum on the audio.  Right 
side...none.
David

----- Original Message ----- 
From: "CSM(r) Gary Huber - AB9M" <glhuber at msn.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Wednesday, November 25, 2009 12:08 PM
Subject: Re: [TenTec] 961 on the left side of rig


> Didn't know it was a problem.. see http://www.csm-gh.com/AB9M-Shack.htm 
> Been running with this configuration for about twenty years, although its 
> been with a Paragon before the current Omni VI Plus.
>
> 73,
>
> Gary - AB9M
>
>
> --------------------------------------------------
> From: "David & Chris Drake" <drakes at psci.net>
> Sent: Wednesday, November 25, 2009 8:35 AM
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Subject: [TenTec] 961 on the left side of rig
>
>> Hi,
>> Anyone know of a shielding workaround to place a 961 power supply on the 
>> left side of the rig?  IE: eliminate hum on the audio.
>>
>> Using a well shielded heil mic into a 715 processor, and a TT supplied 
>> cable to rig.
>> Thanks,
>> David
>> Wd9cmd
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>