[TenTec] WTB: 302R Remote Tuning Pod for Omni VII

[James C. Owen, III]

Also if the knob is not positioned on the shaft correctly the adjustment won't work. It may require that the knob be adjusted to be a little closer to the panel. Set for minimum and then position until the little drag link just touched the panel then you can increase the drag with the adjustment.
73 Jim k4cgy

--- On Sun, 10/18/09, Richards <jruing at ameritech.net> wrote:

> From: Richards <jruing at ameritech.net>
> Subject: Re: [TenTec] WTB: 302R Remote Tuning Pod for Omni VII
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Date: Sunday, October 18, 2009, 4:17 PM
> Really !?!?!?
> It works on mine!   Maybe you just did not
> get 
> the right feel when trying it.   Check
> again, eh? 
> 
> ===========  K8JHR  ================
> 
> 
> 
> > ------------Original Message------------
> > From: "E VICKNER" <rfchoke at verizon.net>
> 
> however I find that there is no way to adjust the 
> > "drag" on the 302 tuning knob like you can do 
> on the Omni VII by holding the knob 
> 
> 
> =======================================
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>