[TenTec] Ten-tec 962 ps problem problem

[Phillip Zminda]

Over the weekend my 962 supply for my Omni VI blew the ac fuse every  
time I turned it on. I expected that the bridge rectifier could be the  
problem. When I opened it up, I found that the bolt holding down the  
filter board was loose leaving the bridge without a heat sink. I  
haven't  unsoldered the bridge but expect that it's the likely  
problem. Has anyone else experienced blown fuse problems with the 962?  
Also, is this a part I can but from Ten-Tec without buying an entire  
board? If not, does anyone know the specs for a direct replacement?  
Since it's a holiday weekend, there's no chance to call Ten-Tec until  
Tuesday.

For me, if anything every breaks around the house, it's on a holiday.  
I've had furnaces go out, dishwashers, stoves and any other number of  
appliances go out on Christmas, July 4 or Memorial Day. This must be  
my 2009 holiday breakdown.

Thanks for any input.

Phil N3ZP