[TenTec] Need: Triton power plug/connector

[Jim Younce]

That is a Cinch-Jones Connector and I think the part number is S-306-CCT. 
You really need to be careful using a power supply that has no over current 
protection built in.  Ten Tec put the protection for the final amplifier 
transistors in the limiting of the current from the power supply and the 
circuit is located in the power supply.  Most of the other manufactures are 
using an SWR circuit in the transceiver that shuts down the drive to the 
finals.  Remember that a 2-1 SWR can be either 100 Ohms or 25 Ohms.  In the 
case of the 25 ohms the current would be excessive.  However if it was 100 
ohms the final would simply draw less current.

73
Jim Younce K4ZM

----- Original Message ----- 
From: "g p" <n2wjw at yahoo.com>
To: <tentec at contesting.com>
Sent: Tuesday, September 22, 2009 9:15 PM
Subject: [TenTec] Need: Triton power plug/connector


Im in search of a power connector for a Triton IV which is the six- three on 
two sides connector, Im using a regular 12v supply (not a TT supply) so just 
the connector with the wires should be what I need.

Please email me if anyone can help me out with this.

Thanks, GIl n2wjw



_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec