[TenTec] help in soldering pl259 outside
Michael Goins
wmgoins at gmail.com
Mon Apr 5 14:53:33 PDT 2010
I use a propane torch. Carefully.
Michael Goins, k5wmg
Professor, Writing
University of Texas at San Antonio
On Mon, Apr 5, 2010 at 4:52 PM, John Molenda <cdistflatfoot at gmail.com>wrote:
> Well it's that time again that is Antenna time . I was out side yesterday
> in 60 degree temp and had a very diffucult time soldering on some
> connectors . Does anyone on the reflector have any tricks for soldering
> outside both my irons were not hot enough . Does anyone make a special
> slodering tool for such a job ? thanks John kb2huk
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list