[TenTec] Red Sweep Screen gone

[Rsoifer at aol.com]

The VOX trip level doesn't seem to affect my sweep display, but my other  
settings may not be the same as Chris's.  Anyway, I totally got rid of the  
red sweep by switching to the waterfall display :-)
 
73 Ray W2RS
 
 
In a message dated 4/11/2010 3:19:59 A.M. GMT Standard Time,  
jrsimon at ozemail.com.au writes:

I'm not  going to look a gift horse in the mouth, my VOX trip is now up to  
100%.

John de VK2XGJ
Money  talks,  Chocolate sings!


----- Original Message -----  
From: "Chris Hinson" <chinson1 at mindspring.com>
To: "Discussion of  Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, April 11,  2010 10:48 AM
Subject: [TenTec] Red Sweep Screen gone


>I  accidently found out how to keep my Orion 2 sweep screen from turning 
red  
>with the newest software.
> This last January while dusting off  the radio I turned on the VOX. I did 
> not realize this until I spoke  to my wife and the relay in the amp 
> clicked. I ID and then turned the  VOX off.
> To keep from doing this again I turned the VOX trip rate up  to 100%.
> After two weeks I realized the red sweep that was a everyday  problem was 
> gone.
> I waited another week and turned the trip  rate back down to 10% and with 
> in two hours the screen turned  red.
> I turned the trip level back up and no red screen for three  months until 
> today when I turned the trip level back down to  10%.
> Can someone tell me how the VOX circuit effects the sweep or is  this 
> something that only works with my O2.
> Thanks in  advance
> Chris K4OSK
>  _______________________________________________
> TenTec mailing  list
> TenTec at contesting.com
>  http://lists.contesting.com/mailman/listinfo/tentec
>  

_______________________________________________
TenTec mailing  list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec