[TenTec] Jupiter Multi encoder

Phil Chambley Sr. k4dpk at comcast.net
Wed Apr 14 21:22:42 PDT 2010


Art....
No, the washer is something I added, because my encoder developed a lot of 
end play and I had to pull on the knob when I turned it to make it work.

Outside re-seating the connectors, I don't have anything else you can try 
except an encoder.

Phil
----- Original Message ----- 
From: "Arthur Lewis" <wa8vsj at ameritech.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Thursday, April 15, 2010 12:15 AM
Subject: Re: [TenTec] Jupiter Multi encoder


> Phil
>
> It has no play at all and it makes no difference if I push the knob in or
> pull it out. I have not tried anything yet and I wonder where the nylon
> washer you mentioned is? Anything is worth a try, but if I have to change
> encoder I will just do it.
>
> Art WA8VSJ
> ----- Original Message ----- 
> From: "Phil Chambley Sr." <k4dpk at comcast.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Wednesday, April 14, 2010 11:52 PM
> Subject: Re: [TenTec] Jupiter Multi encoder
>
>
>> Art....
>>
>> How much end play do you see in the encoder?  If you push it all the wa 
>> in
>> and turn it, does it work properly?  What about pulling it out to the
>> outer
>> end of the end play?  Does it work ok?
>>
>> Not wanting to buy an encoder right away, I drilled an undersize hole in 
>> a
>> nylon washer and pushed it onto the shaft all way against the bushing,
>> while
>> pulling out on the encoder shaft.  This took out the end play and it 
>> works
>> OK now.
>>
>> Phil C. Sr.
>> k4dpk
>> ----- Original Message ----- 
>> From: "Arthur Lewis" <wa8vsj at ameritech.net>
>> To: <TENTEC at contesting.com>
>> Sent: Wednesday, April 14, 2010 5:49 PM
>> Subject: [TenTec] Jupiter Multi encoder
>>
>>
>>> My Multi dial has beome intermittent. It starts to work and goes back to
>>> the lowest level in all funtion modes. Has anyone had this problem and
>>> what if any was the fix? Will something like a tuner cleaner help? Is
>>> changing the encoder the only way out?
>>>
>>> Art WA8VSJ
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 




More information about the TenTec mailing list