[TenTec] [Fwd: Line Isolator Balun (sorta) question.]

Jim Brown K9YC k9yc at audiosystemsgroup.com
Fri Aug 6 10:02:49 PDT 2010


On Fri, 06 Aug 2010 11:48:22 -0500, Dr. Gerald N. Johnson wrote:

>The purpose of these "baluns" is to attenuate any RF current on the 
>outside of the shield. That helps cut feed line radiation when the 
coax 
>is hooked to an antenna. Sometimes that helps cut TVI and received 
>interference from local sources. Sometimes that hurts working 
stations 
>that need the vertically polarized component from feedline radiation.

First, let's call these things by their real name so that we 
understand what they do. They are COMMON MODE CHOKES, NOT BALUNS. 

As Jerry notes, the function of a common mode choke is to kill current 
on the feedline -- that is, to prevent the feedline from acting as 
part of the antenna. That's good for at least four reasons. First, it 
preserves the directional properties of the antenna. Second, it 
prevents the feedline from receiving noise and coupling it to the 
antenna. Third, it prevents the feedline from radiating RF into your 
living room (and your neighbor's living room). Fourth, it prevents the 
feedline from coupling RF into your shack. 

Also as Jerry notes, there is no benefit from using a choke on jumpers 
in the shack. The ideal place for a common mode choke is at the 
feedpoint of the antenna (that is, up in the air where the coax 
connects to the antenna). Chokes are also useful as "egg insulators" 
to break up feedlines into non-resonant lengths (like an egg insulator 
in a guy wire) so that they can not act as parasitic elements to other 
antennas (like a vertical nearby). 

Strings of beads are next to useless at HF frequencies, both because 
their impedance is far too low to be effective, and because they are 
inductive, not resistive at HF. A common mode choke must be resistive 
so that it cannot resonate with the line. If it resonates, it is 
useless. A string of beads IS quite useful at VHF and UHF.  

There is a lot of detail and a tutorial discussion about this in 

http://audiosystemsgroup.com/RFI-Ham.pdf

73, Jim Brown K9YC




More information about the TenTec mailing list