[TenTec] Centurion 422
pfizenmayer
pfizenmayer2 at q.com
Wed Dec 15 17:27:18 PST 2010
Nope - the meters drop 2.38 volts at 1 ma - 2380 ohms and are fed from
fairly large series resistors so the 3.3 volt zeners are fine - in addition
the forward diode tends to damp the meters some as they are pretty undamped.
Hank K7HP
> Most meter coils drop less than 0.1 volt so 3.3 volt zener's aren't much
> protection. Better to use 1N4001 single junction silicon diodes, two in
> parallel opposite polarity. They won't leak any current until the drop
> gets up to about .55 volt.
>
> 73, Jerry, K0CQ
>>
>> 73 de hank K7HP
>>
>>
>>
>>
>>
>>
>> ----- Original Message -----
>> From:<w7ju at cox.net>
>> To:<tentec at contesting.com>
>> Sent: Wednesday, December 15, 2010 3:45 PM
>> Subject: [TenTec] Centurion 422
>>
>>
>>> I had a 3 500Z Gas and blow a line fuse. Replaced the one tube. On
>>> turn
>>> on in standby plate voltage is 3100 but show .2 ma plate current.
>>> Suggestions?
>>> Thanks
>>> Ralph W7JU
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>>>
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list