[TenTec] Centurion 422

pfizenmayer pfizenmayer2 at q.com
Wed Dec 15 19:40:21 PST 2010


I replaced two sets of meters and they have all been around 2400 ohms and 1 
ma full scale. at full scale its 2.3 to 2.4 volts - I have seen no issue 
whatever with the zeners. One could use 3.9 or 4.3 volt zeners if they were 
concerned about a soft knee.

I also talked to the meter manufacturer about whether the surge could in 
fact demagnetize the moving magnet - they also confirm that the meters are 
2300 - 2400 ohms.

K7HP



----- Original Message ----- 
From: "Dr. Gerald N. Johnson" <geraldj at weather.net>
To: <tentec at contesting.com>
Sent: Wednesday, December 15, 2010 7:13 PM
Subject: Re: [TenTec] Centurion 422


>I can't tell from the downloadable manual, but all my life 1 ma meters
> have been more like 50 ohms if quality meters.
>
> 3.3 volt zeners may induce some modification of the meter reading
> because they tend to have a soft knee, not going into strong conduction
> at low current.
>
> 73, Jerry, K0CQ
>
> On 12/15/2010 7:27 PM, pfizenmayer wrote:
>> Nope - the meters drop 2.38 volts at 1 ma - 2380 ohms and are fed from
>> fairly large series resistors so the 3.3 volt zeners are fine - in 
>> addition
>> the forward diode tends to damp the meters some as they are pretty 
>> undamped.
>>
>> Hank K7HP
>>
>>> Most meter coils drop less than 0.1 volt so 3.3 volt zener's aren't much
>>> protection. Better to use 1N4001 single junction silicon diodes, two in
>>> parallel opposite polarity. They won't leak any current until the drop
>>> gets up to about .55 volt.
>>>
>>> 73, Jerry, K0CQ
>>>>
>>>> 73 de hank K7HP
>>>>
>>>>
>>>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 



More information about the TenTec mailing list