[TenTec] Omni VII Serial Port

[d.e.warnick at comcast.net]

Carl, 

Thanks very much. It's working as it should. I had run just TXD, RXD & Signal Ground as used by the Omni VI and completely overlooked handshaking. So, I added 2 wires to the cable and turned on the handshake in N1MM. The real crime is that I worked in data communications for 14 years. Guess I've been retired too long. 



Anyway, thanks again very much. 



Merry Christmas and Happy New Year to you and yours 

73 

Dave 

WA3F 


----- Original Message ----- 
From: "N4PY" <n4py2 at earthlink.net> 
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com> 
Sent: Friday, December 24, 2010 3:15:03 PM 
Subject: Re: [TenTec] Omni VII Serial Port 

57600 baud, 8 bit, no parity, RTS/CTS signalling. 

Carl Moreschi N4PY 
121 Little Bell Dr 
Hays, NC 28635 
www.n4py.com 


----- Original Message ----- 
From: <d.e.warnick at comcast.net> 
To: <tentec at contesting.com> 
Sent: Friday, December 24, 2010 2:52 PM 
Subject: [TenTec] Omni VII Serial Port 


> 
> 
> Just got an Omni VII today. Trying to get it to talk to N1MM or vice 
> versa. Nothing in manual on serial port parameters to set in N1MM and I 
> haven't found anywhere I can set them in the Omni VII 
> 
> 
> 
> Anybody care to point me in the right direction 
> 
> 
> 
> Thanks 
> 
> Dave 
> 
> WA3F 
> 
> 
> _______________________________________________ 
> TenTec mailing list 
> TenTec at contesting.com 
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________ 
TenTec mailing list 
TenTec at contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec