[TenTec] Ten tec Paragon

[N4PY2]

That sounds like your power output is down just enough that you can't reach 
the ALC threshhold with ALC at maximum.  I bet this is not a problem on the 
lower frequencies.

Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com


----- Original Message ----- 
From: "Jeff" <kd4lyh at bellsouth.net>
To: <tentec at contesting.com>
Sent: Friday, February 26, 2010 2:19 PM
Subject: [TenTec] Ten tec Paragon


> Good Day,
> When I rotate the rf power knob fully clockwise I notice my ALC light goes
> out. I still get 100watts out, If I turn it back counterclockwise a little
> then the ALC light stays on. The ALC light use to stay on when I hit tune
> and fully clockwise now it doesn't. Tried in a dummy load and the same
> thing. Anyone know whats out of adjustment and how I can correct this. The
> rig works fine but it never did this before.
>
> Regards Jeff
> No virus found in this outgoing message.
> Checked by AVG - www.avg.com
> Version: 9.0.733 / Virus Database: 271.1.1/2711 - Release Date: 02/26/10
> 02:34:00
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec