[TenTec] Scout 555

[John Peters]

THANKS for letting me know your results    c ya     John 
On Jan 12, 2010, at 12:47 PM, Mike Bryce wrote:

> john...
> 
> I have one that does the same thing. It's not the radio, it's the 40  
> meter module
> 
> I found out by subbing in a different module 40 meter module and lo  
> and behold, the problem went away.
> 
> I popped the module open and did a quick look, looking for a loose  
> ground or other problem. never did find one, so when that module is  
> used and during tx, the display rolls...
> 
> 
> doesn't seem to effect the quality of the signal, just makes the  
> display wobble
> 
> 
> Mike, WB8VGE
> SunLight Energy Systems
> The Heathkit Shop
> http://www.theheathkitshop.com/
> J e e p
> o|||||||o
> Note: No trees were killed in the sending of this message, but a large  
> number of electrons were terribly inconvenienced
> 
> 
> 
> 
> On Jan 12, 2010, at 9:52 AM, John Peters wrote:
> 
>   I have a scout that is acting up... with the 3,14 and 28 Mc units  
> it works just grand.
> But with the 7 Mc unit,  I reads freq' and copies signals just fine.   
> When I
> go to transmit the freq reads out, goes like it was on a ferris  
> wheel.  it just
> don't sit still, until I go back to receive..
>        Any suggestions ? and which half of the unit is for xmit (the  
> xtal for both)
>             Thank you     John     looking for help
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec