[TenTec] Please help with touchy OMNI - D

[Virginia Smith]

Hi All,

 

I've had this OMNI - D since 1998, bought from the original owner who had had it serviced prior to sale, however all the time I've had it, the rig has been very "touchy"  The circuit breaker on the 252M power supply trips often.  I was told by a couple of local TenTec users to consult this list, and that it could be an issue with the power supply or the ALC circuitry - which I have never quite understood how to set.  

 

FYI, I am on an 88 ft doublet antenna, fed with ladder line on an MFJ antenna tuner.  I can tune at low power, but when I go above a few watts I am operating on the edge of shutdown.  There is no evidence of stray RF, as I get reports of a clean signal when I do get on the air.  

 

Also I am currently using the same antenna/tuner setup on a loner Icom rig, and everything is fine.

 

Any ideas?

 

Thanks

 

73

Virginia

KD5EZN

ginnieruth at hotmail.com

 

 
 		 	   		  
_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/196390707/direct/01/