[TenTec] Corsair AGC problem

Steve Hunt steve at karinya.net
Fri Jan 15 04:42:08 PST 2010


Gil,

I had that problem and it turned out to be a faulty front-panel switch. 
You can check by temporarily lifting connector #92 from the IF/AF Board 
- that should bring the AGC on in the FAST mode. If it is that, TT still 
stock the switch.

73,
Steve G3TXQ

g p wrote:
> Just got a used Corsair and the AGC does not come on when the switch is either on slow or fast, it acts as if it were off on all three positions. I have checked the boards for any indications of a bad connection etc, cleaned the switch and still the same. I have had a couple of these rigs before and never seen this problem.
>  
> Would appreciate any comments 
>  
> Thanks, Gil
>
>
>       
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>   



More information about the TenTec mailing list