[TenTec] Orion 2 Firmware 2.044A Released

[John]

So, please help me understand.....

Other than fixing the sweep "picture", what did this upgrade provide over 
39d?  I personally had no issues with 39d, and felt the NR was excellent.

My only "real" request would be that the AGC circuit go back within the DSP 
loop as it was in 1.372.

Thanks folks..........

John W4II
----- Original Message ----- 
From: <Rsoifer at aol.com>
To: <tentec at contesting.com>
Sent: Friday, June 11, 2010 10:38 AM
Subject: Re: [TenTec] Orion 2 Firmware 2.044A Released


> John,
>
> Funny thing about that.  With the mode set to AM, when I hit Tune and 
> then
> Pwr I get full output like you did, but if I hit the PTT button instead,
> all I get is 11 watts on the Bird.  It worked fine with 2.041XT.
>
> 73 Ray
>
>
>
>
> In a message dated 6/11/2010 3:22:43 P.M. GMT Standard Time,
> wb4qda at yahoo.com writes:
>
> Ray
> I just tested my O2 on AM  max output was 80 warrs on an Alpha watt  meter
> also about the same reading on a LP-100A watt meter with the Power set  to
> 100%
> using the new fearmware version 2.044A
> 73
> John  wb4qda
>
>
> ----- Original Message ----
> From: "Rsoifer at aol.com"  <Rsoifer at aol.com>
> To: ronc at sonic.net; w5pny at arrl.net;  tentec at contesting.com
> Sent: Fri, June 11, 2010 8:36:18 AM
> Subject: Re:  [TenTec] Orion 2 Firmware 2.044A Released
>
> Ron,
>
> The NR problem  has been fixed (!) but the old low-output problem on AM is
>
> back.  Mine measures 11 watts carrier power, max.  It  worked  fine with
> 2.041XT.
>
> 73 Ray W2RS
>
>
> In a message  dated 6/11/2010 2:17:05 A.M. GMT Standard Time,
> ronc at sonic.net
> writes:
>
> I have  adjusted the "Wish List" for the Orion II to  reflect the newest
> version of  the firmware.  It's at  www.N6IE.com
>
> Ron  N6IE
> www.N6IE.com
>
> ----- Original  Message ----- 
> From: "Harry G McGavran  Jr"  <w5pny at arrl.net>
> To: <tentec at contesting.com>
> Sent:   Thursday, June 10, 2010 5:50 PM
> Subject: Re: [TenTec] Orion 2  Firmware  2.044A Released
>
>
>>
>> With this one I can set  the side-tone  level all the way
>> up to 65 before the pops begin,  and by the time  one
>> gets past 80 on towards 99 the distortion on  the
>> side-tone  is still really bad -- BUT -- for me at
>>  least, levels are 50-60 are  all I need and that is
>> now  distortion free, at least with a 610 Hz  sidetone
>> which is the  only one I tested or use.  I also  am
>> using the speaker and  not headphones for this.
>> Since one  gets the side-tone every time  the SPOT
>> button is used, the side-tone  distortion was  really
>> objectionable with 2.043B.
>>
>> The  NR seems  better too, but most all the time I don't
>> really need it --  and  it's nice not to have artifacts that
>> sound like NR action on the   side-tone which the side-tone
>> is set to 50-60.
>>
>>  There  are a few CAT wierdnesses here and there, but the  reliability
>> of  sending a strings of "*" commands seems  better.
>>
>> Unless  something else crops up, I think I can  live with this
>>  release...
>>
>> 73 --
>>
>>  Harry,  W5PNY
>>
>>
>>
>>
>>
>> --
>>
>>  Harry G. McGavran, Jr.
>>
>> E-mail:   w5pny at arrl.net
>>
>>
>>
>>   _______________________________________________
>> TenTec mailing   list
>> TenTec at contesting.com
>>   http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> _______________________________________________
> TenTec  mailing   list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec  mailing  list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
>
>
> _______________________________________________
> TenTec  mailing  list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec


--------------------------------------------------------------------------------



No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 8.5.437 / Virus Database: 271.1.1/2931 - Release Date: 06/11/10 
06:35:00