[TenTec] Orion 2 Firmware 2.044A Released

[Rsoifer at aol.com]

Martin,
 
Yes, 25 watts would be right.
 
73 Ray
 
 
In a message dated 6/11/2010 4:12:04 P.M. GMT Standard Time,  
hs0zed at csloxinfo.com writes:

Not sure  what the power 'should be', but a transmitter with a pa rated for
100 watts  pep should give about 25 watts carrier when the ptt is pressed. 
25
watts of  carrier plus 100% modulation would be 100 watts pep, the maximum
the pa is  capable of.

Martin, HS0ZED


-----Original  Message-----
From: tentec-bounces at contesting.com  [mailto:tentec-bounces at contesting.com]
On Behalf Of  Rsoifer at aol.com
Sent: 11 June 2010 22:38
To:  tentec at contesting.com
Subject: Re: [TenTec] Orion 2 Firmware 2.044A  Released

John,

Funny thing about that.  With the mode set  to AM, when I hit Tune and  then
Pwr I get full output like you did,  but if I hit the PTT button instead, 
all
I get is 11 watts on the  Bird.  It worked fine with 2.041XT.

73 Ray




In a  message dated 6/11/2010 3:22:43 P.M. GMT Standard Time,
wb4qda at yahoo.com  writes:

Ray
I just tested my O2 on AM  max output was 80 warrs  on an Alpha watt  meter
also about the same reading on a LP-100A watt  meter with the Power set  to
100% using the new fearmware version  2.044A
73
John  wb4qda


----- Original Message  ----
From: "Rsoifer at aol.com"  <Rsoifer at aol.com>
To:  ronc at sonic.net; w5pny at arrl.net;  tentec at contesting.com
Sent: Fri, June  11, 2010 8:36:18 AM
Subject: Re:  [TenTec] Orion 2 Firmware 2.044A  Released

Ron,

The NR problem  has been fixed (!) but the  old low-output problem on AM is 
 

back.  Mine measures 11  watts carrier power, max.  It  worked  fine  with
2.041XT.

73 Ray W2RS


In a message  dated  6/11/2010 2:17:05 A.M. GMT Standard Time, 
ronc at sonic.net
writes:

I  have  adjusted the "Wish List" for the Orion II to  reflect the  newest
version of  the firmware.  It's at   www.N6IE.com

Ron  N6IE
www.N6IE.com

----- Original   Message -----
From: "Harry G McGavran  Jr"   <w5pny at arrl.net>
To:  <tentec at contesting.com>
Sent:   Thursday, June 10, 2010  5:50 PM
Subject: Re: [TenTec] Orion 2  Firmware  2.044A  Released


>
> With this one I can set  the  side-tone  level all the way
> up to 65 before the pops  begin,  and by the time  one
> gets past 80 on towards 99 the  distortion on  the
> side-tone  is still really bad -- BUT --  for me at
>  least, levels are 50-60 are  all I need and that  is
> now  distortion free, at least with a 610 Hz   sidetone
> which is the  only one I tested or use.  I  also  am
> using the speaker and  not headphones for  this.
> Since one  gets the side-tone every time  the  SPOT
> button is used, the side-tone  distortion was   really
> objectionable with 2.043B.
>
> The  NR  seems  better too, but most all the time I don't
> really need it  --  and  it's nice not to have artifacts that
> sound like NR  action on the   side-tone which the side-tone
> is set to  50-60.
>
>  There  are a few CAT wierdnesses here and  there, but the  reliability
> of  sending a strings of "*"  commands seems  better.
>
> Unless  something else crops  up, I think I can  live with this
>   release...
>
> 73 --
>
>  Harry,   W5PNY
>
>
>
>
>
> --   
>
>  Harry G. McGavran, Jr.
>
>  E-mail:   w5pny at arrl.net
>
>
>
>    _______________________________________________
> TenTec  mailing   list
> TenTec at contesting.com
>    http://lists.contesting.com/mailman/listinfo/tentec
>    

_______________________________________________
TenTec   mailing    list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec   mailing   list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec




_______________________________________________
TenTec   mailing   list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
_______________________________________________
TenTec  mailing  list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

_______________________________________________
TenTec  mailing  list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec