[TenTec] bugs in Orion firmware 2.044A

[Steven Kline]

Yes, thank you Rod and all.  I needed to be more specific in my terminology.  As Rod stated I am speaking of the DSP variable BW.
It was a good suggestion, and I will reload the software load and do the necessary master reset and see if the situation is still there.  Initially when I downloaded the new release there were no error flags displayed but I will do this again and assure there are no issues in that area.

I'll provide another update tomorrow.

Steve - W5JK

On Jun 17, 2010, at 8:36 PM, ROD wrote:

> they are talking the dsp bw not the trsnsmitt bw   i set my dsp bw to 2800 
> turn off and back on the dsp bw goes to 3000
> ----- Original Message ----- 
> From: "Troy W6HV" <w6hv at verizon.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Thursday, June 17, 2010 9:29 PM
> Subject: Re: [TenTec] bugs in Orion firmware 2.044A
> 
> 
>> Ditto with mine. Goes to what I had set previously.
>> Troy, W6HV
>> 
>> --------------------------------------------------
>> From: "Phil Howlett" <w9xx at hoosierbroadband.com>
>> Sent: Thursday, June 17, 2010 5:25 PM
>> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
>> Subject: Re: [TenTec] bugs in Orion firmware 2.044A
>> 
>>> Same here....No problem. Plays very well. Bad download?
>>> W9XX
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec