[TenTec] new N4PY software question.

[N4PY2]

You need an SDR that is capability of making a panadapter screen using 
powerSDR.  This requires a Flex radio of some type.  I believe SoftRock 
radios will also work.  The key is they must be capable of being controlled 
with powerSDR.  Unfortunately, the rx320D will not work for this although 
you can still use the rx320 to produce a low resolution spectrum display 
with the Omni VII or Jupiter.

Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com


----- Original Message ----- 
From: "Richards" <jruing at ameritech.net>
To: "N4PY2" <n4py2 at earthlink.net>; "Discussion of Ten-Tec Equipment" 
<tentec at contesting.com>
Sent: Sunday, March 21, 2010 6:29 PM
Subject: Re: [TenTec] new N4PY software question.


> Can one use a TT 320D receiver with an Omni VII and get the panadapter
> function?   Or will we be left with the original standard N4PY band
> scope feature ? - ( which I thought was cool enough on its own... )
>
> ========================= K8JHR  ==============================
>
> On 3/21/2010 2:42 PM, N4PY2 wrote:
>> Yes, my N4PY software can link any radio supported with N4PY software to 
>> any
>> SDR radio that works with PowerSDR.
>>
> ==============================================================
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec