[TenTec] having problem getting amp to work with Orion II

[John Molenda]

I have reread the manual and looked at the hookup my question is this (when 
hooking Orion II to titan III amp ) there are only two cables to run between 
the two tx en out  key in out .  and then use the switch on the amp in qsk 
mode .  then go to the tx menu and enable loop 1 .  is this correct am I 
missing a hookup ?  thanks John kb2huk
----- Original Message ----- 
From: "aa4nn" <aa4nn at earthlink.net>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Monday, March 22, 2010 9:14 AM
Subject: Re: [TenTec] having problem getting amp to work with Orion II


> Does the term QSK or PTT ring a bell?
> de Joe, aa4nn
> Lake Wylie, SC
> ------------------------------------------------------
>>> Hello all , I am having a problem getting my Orion II to work with my
>>> Titan III
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec