[TenTec] having problem getting amp to work with Orion II

[Barry N1EU]

On Mon, Mar 22, 2010 at 10:19 PM, John Molenda <brazos at rochester.rr.com> wrote:
> I have reread the manual and looked at the hookup my question is this (when
> hooking Orion II to titan III amp ) there are only two cables to run between
> the two tx en out  key in out .  and then use the switch on the amp in qsk
> mode .  then go to the tx menu and enable loop 1 .  is this correct am I
> missing a hookup ?  thanks John kb2huk

Sounds right.  Do you have the two cables correctly connected?  Orion
TX Out 1 to amp Key In and amp Key Out to Orion TX EN 1 assuming
you're using Antenna 1 and have keying loop 1 enabled.

73,
Barry N1EU