[TenTec] Pegasus 550

[phil g]

I never noticed the pull-in voltage.  I had that link bookmarked in my 
pegasus files as a replacement.  I think it came from this list.  I no 
longer have my 550, but maybe someone out there is adventurous and could do 
a voltage check.

There is a 5v version listed, apparently also made of unobtainium.

http://www.newark.com/panasonic-ew/als2b05tw/miniature-power-relay/dp/45M7085

n4zsa
----- Original Message ----- 
From: "Dr. Gerald N. Johnson" <geraldj at weather.net>
To: <tentec at contesting.com>
Sent: Monday, March 29, 2010 2:36 PM
Subject: Re: [TenTec] Pegasus 550


> The part number indicates a 12 volt coil.
>
> 73, Jerry, K0CQ
>
> On 3/29/2010 12:21 PM, Denton wrote:
>> I used to have a Peggy, and one of the relays on the band pass filter 
>> board
>> failed...if I remember right, the relay coils for both input and output 
>> of
>> the filter are wired in series...I replaced mine with two new relays that
>> had 6 volt coils.
>> ----- Original Message -----
>> From: "phil g"<trapperpg at earthlink.net>
>> To: "Discussion of Ten-Tec Equipment"<tentec at contesting.com>
>> Sent: Monday, March 29, 2010 11:04 AM
>> Subject: Re: [TenTec] Pegasus 550
>>
>>
>>> Here is a link to the relay.  Also avail. from Ten Tec.
>>> http://www.newark.com/jsp/search/productdetail.jsp?SKU=45M7086
>>>
>>> Fairly straight forward to replace.  Unsolder the old, solder in the 
>>> new.
>>>
>>> n4zsa
>>> ----- Original Message -----
>>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec