[TenTec] Omni 6+ - no output on 12M/10M

[N4PY2]

I would look into the low pass filter board relays that switch in the low 
pass filters.

Carl Moreschi N4PY
121 Little Bell Drive
Hays, NC 28635
www.n4py.com


----- Original Message ----- 
From: "Barry N1EU" <barry.n1eu at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Saturday, November 27, 2010 11:59 AM
Subject: [TenTec] Omni 6+ - no output on 12M/10M


> My Omni 6+ suddenly has zero power output on 12M/10M tested into a dummy
> load - all other bands fine.  Can someone point me in the direction of
> possible faults?
>
> Tnx/73, Barry N1EU
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec