[TenTec] omni 6+/ power issue

[mike bryce]

I always like to monitor pa current, too

if the current is indicative of producing power, then phil has you in the right area.

if you're drawing 10 amps, and nothing coming out, it's filter problem



just an amp meter on the power supply will work


mike bryce
prosolar at sssnet.com



On Nov 27, 2010, at 4:07 PM, Phil Chambley Sr. wrote:

> The tuner confuses the issue a bit, but are the tuner settings where they 
> normally are for 20m?
> 
> Do you have a frequency counter?
> 
> Phil C. Sr.
> k4dpk
> ----- Original Message ----- 
> From: "Wayne Dial" <w8aju_wdial at att.net>
> To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
> Sent: Saturday, November 27, 2010 4:01 PM
> Subject: Re: [TenTec] omni 6+/ power issue
> 
> 
>> Phil, I'm using a 229b tuner with a current forcing balun and open wire 
>> feeders,
>> at 20w output I can adjust the tuner  for a 1:1 swr.
>> 
>> Wayne
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>