[TenTec] additional info re Corsair ("I") digital readout error

[mike bryce]

this may sound simple, but there's a jumper in the back that goes 'vfo in---vfo out'

make sure the jumper is in place and seated tightly

without it, the counter won't display correctly (radio won't work either!)

mike bryce
prosolar at sssnet.com



On Apr 17, 2011, at 1:25 PM, Trevor wrote:

> Some additional info-
> 
> The readout changes from 91.**** to 9.***** when the
> bandswitch is switched to bands where the Corsair is
> usually in upper sideband mode.  It also changes
> slightly when the mode switch is changed from SB-N to
> SB-R.
> 
> Suggestions appreciated- eager to get the rig on the
> air with minimum spinning of wheels
> 
> 73
> Trevor 
> KD1YT
> 
> 
> 
> ------- Original Message -------
>> From    : Trevor[mailto:kd1yt at pshift.com]
> Sent    : 4/17/2011 1:12:19 PM
> To      : tentec at contesting.com
> Cc      : 
> Subject : RE: Corsair ("I") digital readout error 
> 
> Hello all--
> 
> I'm the original owner of a Corsair ("1" not II)-
> 
> It's always run flawlessly and I have always given it
> good care/ gentle treatment.
> 
> I've had it stored in boxes for a stretch of years
> now (long story about the rest of life) but ever few
> years, have opened it up and slowly run it up on a
> variac just to keep the capacitors formed.  Last time
> I did that, a bit less than two years ago, all seemed
> well.
> 
> Today I got it out and "brought it up gradually"
> again with the aim of putting it on the air again,
> but the digital readout is reading something like
> 91.000.01-- and does not change regardless of
> switching bands or rotating the VFO.  Turning it off
> and on again does not seem to change anything.
> 
> Suggestions appreciated!
> 
> 73
> Trevor
> KD1YT
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>