[TenTec] need help getting a Pegasus up and running

[jack]

do you have the baud set properly? the Orion runs at a very high baud
rate. don't know about the Pegasus.

jack
ak7o


On Sat, 2011-04-23 at 19:06 -0400, yash at aol.com wrote:
> 
>  Using the TT software from the TT down load site.  Computer is xp with sp-3 and 4 gig of ram. Software loads fine on computer. Using a usb to serial cable,which on the device controller says its in place and working fine and is set on com 3. I went into the TT software and changed from com1 to com3 . turned on the Pegasus and started the software the two could not communicate with each other. tried all 6 different com port settings ,nothing changes. re loaded the TT software ,no change. What about the Baud rate and priority stuff,make a difference? could find no where the TT requirements for rates etc. 
>      I just got this Pegasus, was told it worked fine ...don't they all say that... I will buy the N4PY software as soon as I make sure the basic Pegasus is working ok. But need to get it up and on line with what I have.
> 
> Maybe the usb/serial cable a bad thing??
> can put a serial card in if needed . 
> 
> Sure would be grateful for any help on this. After using a flex 5000 and power sdr   for 4 years,thought the little Pegasus would be a no brainier.
> Thanks
> dale wt4t
> 
>  
> 
> 
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec