[TenTec] need help getting a Pegasus up and running

[Carl Moreschi]

First, you can download my N4PY sofwtare and run it on a 10 day free 
trial.  Just go to my website at www.n4py.com and then go to the Pegasus 
Downlaod page under the "More" Menu.  Download n4py319M.exe.

The baud rate is fixed at 57600 and both the Tentec program and N4PY set 
this up.  The only setting you need to make is for the correct comport 
number.


Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 4/23/2011 7:06 PM, yash at aol.com wrote:
>
>
>   Using the TT software from the TT down load site.  Computer is xp with sp-3 and 4 gig of ram. Software loads fine on computer. Using a usb to serial cable,which on the device controller says its in place and working fine and is set on com 3. I went into the TT software and changed from com1 to com3 . turned on the Pegasus and started the software the two could not communicate with each other. tried all 6 different com port settings ,nothing changes. re loaded the TT software ,no change. What about the Baud rate and priority stuff,make a difference? could find no where the TT requirements for rates etc.
>       I just got this Pegasus, was told it worked fine ...don't they all say that... I will buy the N4PY software as soon as I make sure the basic Pegasus is working ok. But need to get it up and on line with what I have.
>
> Maybe the usb/serial cable a bad thing??
> can put a serial card in if needed .
>
> Sure would be grateful for any help on this. After using a flex 5000 and power sdr   for 4 years,thought the little Pegasus would be a no brainier.
> Thanks
> dale wt4t
>
>
>
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>