[TenTec] Omni VI + Interconnect Schematic

[Barry N1EU]

There is no interconnect drawing in either the 563 or 564 manuals.

73, Barry N1EU

On Sat, Dec 10, 2011 at 5:46 PM, Clayton Brantley
<clayton_n4ev at yahoo.com> wrote:
> Wayne:  I have an Omni VI rev 3 and I'm sure there is a drawing the the 563 manual.  I'll look a bit later
> today for you.
>
> I did a quick check on the 564 book that I downloaded and you're right!  It's missing!
>
> 73 Clayton N4EV
>
>
>
> ________________________________
>  From: n2wk <n2wk at rochester.rr.com>
> To: tentec at contesting.com
> Sent: Saturday, December 10, 2011 12:03 PM
> Subject: [TenTec] Omni VI + Interconnect Schematic
>
> Is there a drawing (schematic)for the Omni VI+ showing all of the interconnect boards available?
> I do not have one in my Omni VI Plus manual. This would be a large Drawing showing the entire layout of the connections from board to board. I could use one. Anybody Please.
>
> 73, Wayne N2WK
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec