[TenTec] Orion s-meter calibration

[Barry N1EU]

I've never seen a description of what those values mean.  I just
played with them until the Orion s-meter responded similarly to a
known good receiver's s-meter.  I can't really recommend that anybody
else changes those values.

Barry N1EU

On Sat, Dec 31, 2011 at 9:17 PM, Tom Berry <tberry1 at triad.rr.com> wrote:
> Let me see if I understand this function.  I would select an S meter
> value (say S9) then change the digital count so that the S meter reads
> S9.   Is that correct?
>
> 73 Tom AA4VV
>
>
>
> On 12/31/2011 3:48 PM, Barry N1EU wrote:
>> Thanks - it's uncharted territory in there but I think I managed to
>> improve things.  I was careful to record the original values before
>> mucking around.
>>
>> 73, Barry N1EU
>>
>> On Sat, Dec 31, 2011 at 7:18 PM, AL7CR<al7cr at punakea.com>  wrote:
>>> Go to the RX menu and press the 15m band select key.  This will bring up
>>> a screen that allows you set the S meter in digital counts.
>>>
>>> AL7CR
>>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec