[TenTec] CorsairII notch potentiometer

[Steve Hunt]

Charles,

>
> I thought I gathered from your description that you actually ended up
> using wires to extend the pot leads.  Or maybe I misread?

I needed to extend by about 2mm, so I inserted short terminal pins into 
the PCB and soldered the pot directly to them. It's as if the pot pins 
were 2mm longer - not enough to do any swap over.

> Couldn't you just remember that the "out" position was at the CCW
> end, same as you'd remember that the frequencies were reversed from
> their normal relations?  If the now-extraneous panel marking bugs
> you, you could cover it with tape -- or if the panel is metal with
> silkscreened graphics, some methylene chloride and a Q-Tip will take
> it right off (if the front panel has a plastic overlay, don't try this).

Yes, I could - but I was looking for a solution that kept the Corsair 
front panel and functionality "untouched". It's looking like that might 
be impossible!

73,
Steve G3TXQ