[TenTec] Audio Output Questons for an Orion 565

[Martin Sole]

Eric,

The AUX I/O connector has independent outputs for main and sub receiver.
These are at a fairly low level but will drive a typical stereo amplifier
that can be used to feed separate speakers for the two receivers.

Martin, HS0ZED


-----Original Message-----
From: tentec-bounces at contesting.com [mailto:tentec-bounces at contesting.com]
On Behalf Of Eric Rosenberg
Sent: 24 February 2011 01:03
To: tentec at contesting.com
Subject: [TenTec] Audio Output Questons for an Orion 565

My Orion 565 has been sitting on the bench for a while, so I'm rusty when it
comes to hooking it up.

1.  I'd like to have the ability to feed a speaker and headphones
simultaneously (as one can do with a K3). I already use the line output to
go to my MicroKeyer 2.  Any suggestions on how to do this?

2. The speaker output is mono. I'd like to have the ability to send Main
audio to one speaker, Sub RX to the other. Can I, and how?

Thanks & 73,
Eric W3DQ
Washington, DC
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec