[TenTec] Omni VI+ Frequency Display Problem Only On LSB

[Carl Moreschi]

The internal BFO frequency adjustment for LSB is off 250 hertz.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 6/9/2011 9:59 PM, Tom Stone wrote:
> Has any owner of an Omni VI+ ever had a problem similar to this? (With the
> RIT off, Identical Side tone and Pass Band Tuning set at zero on both rigs)
>
>
>
> Switching between my Orion II and Omni VI+ using an Alpha Delta switch on
> the same antenna. The Omni was just serviced by Ten Tec.
>
>
>
> 160M - LSB - Orion II 1.900.000 For the same voice quality (sounds the same)
> the Omni had to be tuned to 1.899.75
>
>
>
> 80M - LSB - Orion II  3.868.000 For the same voice quality (sounds the same)
> the Omni had to be tuned to 3.867.75
>
>
>
> Question: What could account for the consistent .25 difference in the
> frequency read out?        There is no difference when I am in the USB mode.
>
>
>
> Would appreciate any available input.
>
>
>
> 73,   Tom  N3XQ
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>