[TenTec] Pegasus Control, new PC, port problems

[Richards]

Hi Art -- I would check the baud rate.  Should be specified
in the user manual.

I do not have a Pegasus, but that often resolves issue I see
with my Omni VII,  RX-230D, and TS-590s --  all of which seem to
have similar issues when I do a re-build, and the baud rate is
often the sticking point.  No guarantees, but I would check that
out as you suggest.

In any case, if that is not the issue, then you have eliminated
that as the problem.

------------------
Happy Trails.
=======================  Richards / K8JHR  =========================

On 6/19/2011 00:57, Art Trampler wrote:

> However, I haven’t been able to get the Pegasus recognized.

> Is there a particular Baud I should select?
>
>______________________________________________________________