[TenTec] Default LCW BW 1000Hz

[Rsoifer at aol.com]

Hi John,
 
I just did some experimenting.  I generally use UCW, but for this test  I 
set the O2 to LCW and turned it on.  It came up at 2400 Hz.  I  then set BW 
to 500 Hz, turned off the radio, and turned it back on.  2400  Hz.  Then, I 
set it to 500 Hz again and cycled the band button through its  4 stack 
memories.  Success!  After turning the rig off and on, it now  comes up at 500 Hz. 
 
 
73 Ray W2RS
 
 
In a message dated 3/20/2011 5:45:02 P.M. GMT Standard Time, k3ghh at arrl.net 
 writes:

On  03/20/2011 12:48 PM, pfizenmayer wrote:
> By any chance do you have the  RX>BW track or RX>PBT track turned on ? 
That 
> might be doing it  .
>
> Hank K7HP
>
> ----- Original Message -----  
> From: "John K3GHH" <k3ghh at arrl.net>
> To:  <TenTec at contesting.com>
> Sent: Sunday, March 20, 2011 5:10  AM
> Subject: [TenTec] Default LCW BW 1000Hz
>
>
>>  After a recent update of O2 firmware to 2.044A, when I first turn  the
>> rig on its bandwidth (on LCW mode) is 1000 Hz. When I turn the  rig off
>> the bandwidth is usually 500 Hz and often less ---  certainly never
>> anything near as wide as 1000. How do I change  this boot-up default
>> bandwidth?
>>
>> --  
>> John K3GHH
>>
>>  _______________________________________________
>> TenTec mailing  list
>> TenTec at contesting.com
>>  http://lists.contesting.com/mailman/listinfo/tentec
>>
>  _______________________________________________
> TenTec mailing  list
> TenTec at contesting.com
>  http://lists.contesting.com/mailman/listinfo/tentec
>
Thanks, Hank...  but they're both off.

-- 
John  K3GHH

_______________________________________________
TenTec mailing  list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec