[TenTec] O3 wish list

[Barry N1EU]

Yes, but aren't many folks going to need a computer upgrade to
efficiently run PowerSDR if they have older single core cpu's?

Barry N1EU

On Thu, May 12, 2011 at 10:57 PM, CSM(r) Gary Huber <glhuber at msn.com> wrote:
> Well, 1st off you'd have to go for the IF.... and that’s why I prefer the
> N4PY sub-r mod and the FLEX-1500 running in panadapter mode using PowerSDR.
> $650, ten minute (no solder mod) and away you go, without risking your
> expensive radio to a soldering iron.
>
>
> 73 es DX,
>
> Gary - AB9M
>
> -----Original Message-----
> From: John Molenda
> Sent: Thursday, May 12, 2011 9:50 PM
> To: k9yc at arrl.net ; Discussion of Ten-Tec Equipment
> Subject: Re: [TenTec] O3 wish list
>
> On 5/12/2011 10:35 PM, Jim Brown wrote:
>> On 5/12/2011 3:35 PM, CSM(r) Gary Huber wrote:
>>> At $650, the FLEX-1500 is about the cheapest panadapter one can buy.
>> The P3 costs $700 as a kit, which takes about an hour to build. It's a
>> pre-tested board for which you screw together a simple enclosure and
>> mount a few connectors.  Yes, it can be easily set for a wide range of
>> IF frequencies via a menu setting.
>>
>> 73, Jim K9YC
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>
> But how does it work with Ten Tec orion II ?
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>