[TenTec] Building TenTec Receiver 1254 Kit Question

[James Duffer]

A wise decision.  It is much more hassle to remove components when the board is totally populated.  Building in stages and testing as you go is a wise move.

fwiw

73, Jim   wd4air

> Date: Sun, 15 May 2011 23:36:32 -0400
> From: jruing at ameritech.net
> To: tentec at contesting.com
> Subject: Re: [TenTec] Building TenTec Receiver 1254 Kit Question
> 
> I was afraid someone would say that...   so I waited.
> 
> Common sense is not much fun... at least in the short run.
> 
> Thanks for the uptake.    I will build something else in the mean time.
> 
> ------------------
> Happy Trails.
> =======================  Richards / K8JHR  =========================
> 
> On 5/15/2011 11:30 PM, William Miner wrote:
> > My advice would be to wait for your Elmer. The 1254 is a somewhat complex kit if you are not an experienced builder.  Doing the testing in stages can save you from a lot of problems.  Just my opinion.  73,  Bill
> >
> _________________________________________________________________
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec