[TenTec] OMNI D Accessory Jack Pinout

Joe joe at n4yg.com
Sun Nov 6 11:15:55 PST 2011


Thanks Barry. Now I am confused. N4RS provided a pinout which is very 
different from this. Could someone please clarify. Maybe there is more than 
one configuration.

Joe
----- Original Message ----- 
From: "Barry N1EU" <barry.n1eu at gmail.com>
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com>
Sent: Sunday, November 06, 2011 8:58 AM
Subject: Re: [TenTec] OMNI D Accessory Jack Pinout


> Here's what I'm seeing:
>
> 1.  T  (transmit control sig)
> 2.  +REG
> 3.  +13
> 4.  REM VFO
> 5.  LO
> 6.  MUTE C
> 7.  MUTE NO
> 8.  GND
> 9.  MUTE NC
>
> 73, Barry N1EU
>
> On Sun, Nov 6, 2011 at 1:46 PM, Joe <joe at n4yg.com> wrote:
>> I need to know the pinout of the 9-pin OMNI D accessory jack. I have 
>> looked a several of the online manuals and everyone is missing the block 
>> diagram which has this information. I am guessing that it is the same as 
>> the Corsair II. If someone could give me the info or point me to a 
>> complete manual I would appreciate it.
>>
>> Joe, N4YG
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 




More information about the TenTec mailing list