[TenTec] Omni D PTO Swap

[Mike Hyder -N4NT-]

Have you perchance considered ordering a kit of PTO rebuild parts from 
Ten-Tec and overhauling the poor PTO?

73, Mike N4NT

----- Original Message ----- 
From: "Hulett, Russell" <rhulett1 at consolidated.net>
To: <TenTec at contesting.com>
Sent: Wednesday, November 16, 2011 6:20 PM
Subject: [TenTec] Omni D PTO Swap


> If I remove the entire PTO assembly from one Omni D and install in 
> another, are there any adjustments needed other than the L1, L2, & L3 
> adjustments on the PTO to set the oscillator endpoints and linearity?  I 
> have one rig with a smooth PTO but numerous "issues" otherwise, another 
> with poor PTO but no "issues" otherwise.
>
> Thanks in advance & 73, Curt KB5JO