[TenTec] trouble interfacing OMNI VI to N1MM via serial port

[Barry N1EU]

ground is pin 7 and Joe had that:  "Pin 5 on DB9 connects to pin 7 on the DB25"

1200 baud works fine

73, Barry N1EU

On Fri, Nov 18, 2011 at 11:34 AM, Ed <autek at comcast.net> wrote:
> On 11/17/2011 12:36 PM, Joseph Holstein wrote:
>> followed instructions in the TenTec manual and have pins 2 and 3 and
>> 7 on the DB 25 going to the DB 9 . DB 9 has pins 4 and 6 shorted.
>> Followed directions in N1MM for Omni VI - 1200 baud etc.  Pin 5 on
>> DB9 connects to pin 7 on the DB25.  Any suggestions ? 73 joe n8ea
>> _______________________________________________ TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
> You need pins 2, 3, and 5. on the db9. You need pins 2, 3, and whatever
> the pin is for ground on the db 25. Thats all.
>
> 1200 baud is way too low for the 6. Set the baud to maximum.
>
> Ed W3NR
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>