[TenTec] help with Corsair II tx/rx off freq issues

[Barry N1EU]

Check BFO oscillator alignment.  It's easy to do if you have a freq
counter or accurate general coverage receiver.  Instructions are in
the manual.

73, Barry N1EU

On Mon, Nov 21, 2011 at 2:13 AM,  <scottsheppard at videotron.ca> wrote:
> I just recently picked up a lovely Corsair II (to add to the TT madness) and the DDS kit from N4YG,,,the difference, by the way, is amazing and makes the rig an even greater pleasure to use than before.
>
> Upon installing it and actually using the rig a bit, however, I note that my Tx and Rx freq are not aligned. Its not that the rig display may be a bit off but rather the station signal I am listening to is on one freq and when I transmit back, I am about 600hz off (as though working split--which I am not), I did not adjust anything else after the install but the issue may have been pre-existing.
>
> Seems to me I had similar issues on an older Omni A but don't recall what I tweeked or balanced...any thoughts from the Corsair crowd?
>
> 73
>
> scott va3ied
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>