[TenTec] Problem with my pegasus

[Carl Moreschi]

Make sure you have the very latest firmware from tentec.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com


On 11/28/2011 3:27 PM, BUDW2GLN at aol.com wrote:
> I have a model 550 Pegasus and I am using the standard software that TenTec
>   provides.  I have several pieces of TenTec gear but have been spending a
> lot of time using the 550...I am fascinated with it.....
>
> I brought it up on ten meters for the first time the other day and noticed
> that I had only a couple of watts maybe 3 out on AM with the power level up
> at  max. Further investigation revealed that SSB and CW output were A OK on
> all  bands......BUT   to achieve 25 watts AM, the 80mtr AM  setting was
> normal.....40mtrs required 2/3 setting...... 20mtrs required full  setting
> .....15mtrs would give out aprox 8 watts at full setting and, as I said,  10mtrs
> almost no output.........Any suggestions  ???
>
> Thanks
>
> Bud  W2GLN
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>