[TenTec] new RX366 sub receiver

[Tony Lelieveld]

Will it be full coverage or ham band only? Thanks Tony VE3DWI. 
Sent wirelessly from my BlackBerry device on the Bell network.Envoyé sans fil par mon terminal mobile BlackBerry sur le réseau de Bell.

-----Original Message-----
From: Carl Moreschi <n4py2 at earthlink.net>
Sender: tentec-bounces at contesting.com
Date: Thu, 13 Oct 2011 16:34:26 
To: Discussion of Ten-Tec Equipment<tentec at contesting.com>
Reply-To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
Subject: Re: [TenTec] new RX366 sub receiver

I was not a beta tester but I saw one at the Tentec hamfest and talked 
with John Henry about it.  It is an exciting thing for the Orion.

Carl Moreschi N4PY
121 Little Bell Dr.
Hays, NC 28635
www.n4py.com

On 10/13/2011 4:08 PM, Tom Berry wrote:
> Carl, I saw your reply on the TenTec list.
>
> Were you  a Beta tester?  If so..  How does it work?  I am really
> looking forward to getting the rx366.
>
> Thanks
> 73 Tom AA4VV
>
>
> On 9/27/2011 8:52 AM, Carl Moreschi wrote:
>> The new rx366 board is simply a replacement board for the existing
>> sub-receiver board.  It is a very easy field replacement.  It will
>> require the new orion version 3 firmware.  There are 3 roofing filter
>> slots in this receiver and it does have a switchable preamp.  It will be
>> available for both the Orion and Orion II.
>>
>> Carl Moreschi N4PY
>> 121 Little Bell Dr.
>> Hays, NC 28635
>> www.n4py.com
>>
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec at contesting.com
http://lists.contesting.com/mailman/listinfo/tentec