[TenTec] Omni 6+ RIT Tuning Rate

[Michael Tope]

Sure enough. That did the trick. Thanks Gert and Barry!

73, Mike W4EF...........

On 9/11/2011 6:58 AM, Barry N1EU wrote:
> rSPD sets SSB RIT rate and CrSP sets cw RIT rate.  OP set SSB rate
> instead of CW rate.
>
> 73, Barry N1EU
>
> On Sun, Sep 11, 2011 at 1:17 PM, Gert Meinen<pa3aav at hetnet.nl>  wrote:
>> Mike,
>>
>> In my Omni VI opt 3 there is in menu 3 the option CrSP this sets the rate of
>> the offset tuning knob in CW mode in kHz per turn  from 4.8 to .15 kHz in
>> six steps.
>>
>> Hope this helps,
>>
>> 73 Gert, PA3AAV
>>
>>
>> ----- Original Message -----
>> From: "Michael Tope"<W4EF at dellroy.com>
>> To:<tentec at contesting.com>
>> Sent: Sunday, September 11, 2011 12:30 PM
>> Subject: [TenTec] Omni 6+ RIT Tuning Rate
>>
>>
>>> My frustration with the fast tuning rate on my Ten-Tec Omni 6+ RIT
>>> function finally exceeded my "I should do something about this"
>>> threshold last night during the CW Sprint contest. I just changed the
>>> setting in the hidden options menu 3 (i.e. rSPD) from 4.8 KHz/turn to
>>> 0.15 KHz/turn. This didn't have any effect on the tuning rate. Is there
>>> a hardware and/or firmware change that is required to make this
>>> particular menu parameter function properly?
>>>
>>> Thanks,
>>>
>>> Mike W4EF.......................
>>>
>>> _______________________________________________
>>> TenTec mailing list
>>> TenTec at contesting.com
>>> http://lists.contesting.com/mailman/listinfo/tentec
>> _______________________________________________
>> TenTec mailing list
>> TenTec at contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec