[TenTec] The Corsair II Display Logic PCBs
Keith Hamilton
tuner at zoominternet.net
Wed Sep 21 17:52:43 PDT 2011
Thank you sooo much!
Keith N8CEP
Sent from my iPhone
On Sep 21, 2011, at 8:07 PM, "Jerry Haigwood" <jerry at w5jh.net> wrote:
> Folks,
>
> The Corsair II Display Logic PCBs came in on Monday. I was out of town
> at a funeral and got back late. Today, I sent most all orders out. The
> only ones not sent were the ones who wanted me to build the board. Those
> will go out over the next few days. For those who ordered kits, I included
> some simple directions on how to build the board and also how to install it.
> If you ordered the PCB only, I sent a parts list along with the board. I
> notice I have one error on the parts list, I left the two electrolytic
> capacitors off of the list. C7 should be a 1000uF at 25VDC electrolytic and
> C9 is a 33uF at 25VDC electrolytic capacitor. It is hard to see the
> component designators on some of the small capacitors. Please refer to
> Steve Hunt's web page:
>
>
>
> <http://www.karinya.net/g3txq/corsair_display/silkscreen.pdf>
>
>
>
> to see the markings. I have built one board to see how well the parts fit.
> For the most part, they all fit well. Some of the capacitors have a
> distance between the legs of 0.1 inch and the holes on the PCB are a bit
> wider apart. You will just have to bend the legs a little to fit them into
> the holes. It took me less than 1 hour to assemble the board and I am not
> exceptionally fast. The eyes are just not as good as they once were
> although they are not bad for a guy who has been a diabetic for 42 years!
> Have fun building the board. It is a nice little kit.
>
> 73, Jerry W5JH
>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
More information about the TenTec
mailing list