[TenTec] new RX366 sub receiver

[d.e.warnick at comcast.net]

As always, Thanks John. 

Dave 

WA3F 





----- Original Message -----


From: "John Henry" <jhenry at tentec.com> 
To: "Discussion of Ten-Tec Equipment" <tentec at contesting.com> 
Sent: Tuesday, September 27, 2011 8:54:54 AM 
Subject: [TenTec] new RX366 sub receiver 

Current plan is, the new RX366 will be available as: 

1 - You purchase a kit, install yourself. Fairly simple. Remove 
top/bottom, remove tmps to current A6 sub receiver, remove screws, 
screw down RX366 system board, install "eagle" parts (simple), 
reinstall tmps. program in version 3 firmware, do master reset, answer 
Yes to "RX366 Installed" prompt. Cost = tbd. Definitely will not come 
anywhere near the cost of an Orion III. Not going to be expensive at 
all. JMHO. 
2 - You send it in to TenTec to do. Cost = cost of new sub receiver + 
x hours labor. 
3 - You purchase a new Orion II with it installed instead of existing 
A6 sub receiver. Haven't worked this one out exactly yet. 

Now, to get to testing it again so that we can ship it.... 
Take care, 
John Henry 
_______________________________________________ 
TenTec mailing list 
TenTec at contesting.com 
http://lists.contesting.com/mailman/listinfo/tentec