[TenTec] new RX366 sub receiver

k3miy at csonline.net k3miy at csonline.net
Tue Sep 27 07:49:22 PDT 2011


Typo maybe :-)

Ron K3MIY

Quoting kc9cdt at aol.com:

> 
> ORION 3 ??????
> What Orion 3?
> 73,
> Lee
> 
> 
> -----Original Message-----
> From: Henry, John <jhenry at tentec.com>
> To: Discussion of Ten-Tec Equipment <tentec at contesting.com>
> Sent: Tue, Sep 27, 2011 8:55 am
> Subject: [TenTec] new RX366 sub receiver
> 
> 
> Current plan is, the new RX366 will be available as:
> 
> 1 - You purchase a kit, install yourself. Fairly simple. Remove
> top/bottom, remove tmps to current A6 sub receiver, remove screws,
> screw down RX366 system board, install "eagle" parts (simple),
> reinstall tmps. program in version 3 firmware, do master reset, answer
> Yes to "RX366 Installed" prompt. Cost = tbd. Definitely will not come
> anywhere near the cost of an Orion III. Not going to be expensive at
> all. JMHO.
> 2 - You send it in to TenTec to do. Cost = cost of new sub receiver +
> x hours labor.
> 3 - You purchase a new Orion II with it installed instead of existing
> A6 sub receiver. Haven't worked this one out exactly yet.
> 
> Now, to get to testing it again so that we can ship it....
> Take care,
> John Henry
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> _______________________________________________
> TenTec mailing list
> TenTec at contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 
> 




-------------------------------------------------------------------
This mail sent through CSOnline Webmail http://webmail.csonline.net



More information about the TenTec mailing list